· Lightbulb (100w)
· Socket (duh...)
· ¬ cup soap chips
· Blackpowder! (open some shotgun shells!)
· ¬ cup kerosene or gasoline
· Adhesive tape
· Lighter or small blowtorch
· Glue
Procedure for a simple exploding lightbulb:
1.Drill a small hole in the top of the bulb near the threads!
2.Carefully pour the black powder into the hole. Use enough so that it touches the filament!
3.Insert into socket as normal (make sure the light is off or else YOU will be the victim!!)
4.Get the hell out!!
Procedure for a Napalm Bulb:
1.Drill a small hole in the top of the bulb near the threads!2.Carefully pour the blackpowder into the hole. Use enough so that it touches the filament!
3.Insert into socket as normal (make sure the light is off or else YOU will be the victim!!)
4.Get the hell out!!
Procedure for a Napalm Bulb:
1.Heat kerosene/gasoline in a double boiler.
2.Melt soap chips, stirring slowly.
3.Put somewhere and allow to cool.
4.Heat the threads of the bulb VERY carefully to melt the glue. Remove threads, slowly drawing out the filament. Do NOT break the cheap electrical igniters and/or the filament or this won't work!!
5.Pour the liquid into the bulb, and slowly lower the filament back down into the bulb. Make sure the filament is dipped into the fluid.
6.Re-glue the threads back on. Insert it into a socket frequently used by the victim and get the hell out!!
When the victim flips the switch, he will be in for a BIG surprise!
No comments:
Post a Comment